Page Comparison

Connect the Battery and or Power Supply here

Battery Connected show here

PL mount lens and locking mechanism

Mount the lens as shown

This is the shoulder mount plate on the bottom of the camera


Slide the shoulder mount on to the plate and make sure it locks in place

Connect the Pistol Grip or Lens grip
power and control cable
shown here

Connect the mounting bracket for the grip shown here

mounting bracket for the grip shown here


Tighten the bracket with the wing nut type thumb screw

Here is an example of how the pistol grip looks all setup

Press the Door Hinge to open the Card Slot door

Insert a P2 and an SD card

P2 for the Hi Res recording and SD for Proxy recording
MUST USE BOTH CARDS or the camera wont record

Turn on the power button to the camera

Format the Cards before you record


Press Menu

Choose System Settings by Pressing the knob at the right of the screen

Scroll down to Cards/Media

Choose Format Media

Format the Card in the Main Slot = P2 and the Sub Slot = SDHC slot

Re-Set the camera to Factory Settings because that is the most used settings. It will set the camera to 4K 23.98 recording to the P2 and HD 1080 proxy files recording to the SD card

Choose System Settings by Pressing the knob at the right of the screen

Choose Initialize

Load Factory Data

Choose YES to Restart the System and restore Factory Defaults

To Auto White Balance on a white board use the AWB Hold button

Press the VIEW button to put the monitor in Viewing mode

Press the REC button to start recording

This button toggles recording on and off

To adjust the Overcrank and Undercrank press the VFR white button on the "Home" page of the camera "Control Panel"

Press the same white button again to turn "ON" VFR and then turn the knob to what frame rate

4K only will go to 30FPS overcranking
and 2 fps undercrank
2K will go to 60 FPS over crank