Check that the WHITE Thunderbolt cable is plugged into the IMac |  | |
| Make sure the other end of the WHITE - Thunderbolt cable is plugged into the Blackmagic Design Intensity Pro as shown here. |  | |
| Log into the computer | ||
|
| |
|
| |
Click on Settings Button |
| |
Click on Video> |
| |
Click on Audio Tab (if there is one) > Click on RCA
Close the Desktope Video click the red button in the corner |
| |
Back to System Preferences
Select Sound |
| |
Select Output Tab > Blackmagic AudioOption |
| |
If you have video you would like to use in your protools session turn on the TV MAKE SURE THAT THE SOURCE IS SET TO COMPONENT - |
| |
PRESS THE SOURCE BUTTON UNDERNEATH THE "9" KEY TO SET INPUTS ON THE MONITOR - Don't change this should be set correctly but just in case it should be set to component input. |
| |
If you are in suite CMB 1.108B then you have a newer Monitor and have this remote Power and Input buttons will be what you need. Input should be on HDMI |
| |
Select the application that you want to run AVID or Davinci Resolve or Premiere |
| |
| Choose "Premiere Pro CC > Preferences > Playback..." |  | |
Choose Blackmagic Playback
Click OK |  | |
| Choose "Premiere Pro CC > Preferences > Audio Hardware..." |  | |
| Make sure you Preferences look like this |  | |
| If you get this error click Yes |  | |
| Click OK | ||
Don't forget to pan channel 1 LEFT & channel 2 RIGHT and don't use any other tracks |  | |
USE ONLY TRACK MIXER not CLIP MIXER |  | |
Some of the Suites on the 1st floor have a Mixer. The mixer settings are shown here.
Channel 1 and 2 are AVID playback are ProTools playback
Also turn up the Master audio on the Board labeled Volume |
| |
Some suites have the Mackie Big Knob ProTools and AVID Inputs are labeled and use Monitor Select B make sure Mute is not pressed |
|
| Anchor | ||||
|---|---|---|---|---|
|