...
While designing the mechanism, we let the original goal and the kinematic requirements control as many parameters as possible, and optimized the rest for
simplicity of design and robustness.
The actuator, a 1:131 Pololu motor/gearbox combination, drives a single 9-bar mechanism. The mechanism consists of a 4-bar and 6-bar linkage which share one
link and are coupled using a gear train.
...
The 4-bar mechanism is used to oscillate the main tower back and forth between two positions that are 180 degrees apart. This mechanism passes through a
toggle position in the middle of its motion, when all the links align. In our design, the tower has enough inertia to force the linkage through this toggle
position and cause it to oscillate correctly.
We used Matlab to find the proper link lengths for this linkage. The requirements were as follows:
The mechanism must be Grashof (because the linkage works with a single continuously-rotating motor)
The ground link must be no 12 inches long (to fit within device bounds)
The limits of the joint motion must be 180 degrees apart.
By using the last requirement, the Pythagorean theorem can give the relationship between three lengths: the ground link, output link,
and the sum of the coupler and driving link. The Grashof condition puts limits on the link lengths but does not dictate the lengths, so this is a bounded system
of equations that has infinite solutions. We chose an input link length of 4 inches and output length of 5 inches to maintain a reasonable mechanical advantage.
...
| Widget Connector | ||||
|---|---|---|---|---|
|
We solved this issue by creating slots in the motor mount which allowed it to slide forward and back. This meant that the linkage a) had more play, and b) could build up more momentum to power through the toggle position. Given the amount of issues that we had with this particular portion of the design, we strongly suggest against designing a linkage to pass through a toggle position.
...
We wanted this linkage to sweep out approximately 90 degrees. Since it is being driven by a bevel gear attached to the tower rotation coupler,
its input which is already oscillating. This removes the need for a Grashof mechanism. The input angle has a range of over 210 degrees, which is
the total sweep of the joint between the horizontal coupler and the tower. This dictated the use of a 3:1 gear ratio, giving and output of approximately
70 degrees for vertical motion.
...
Most of the joints in the assembly consist of a single bearing, 1/4" machine screw, and 1/4" locknut, with washers if necessary. This joint design
allows the bolt (the joint pin) to freely rotate while still preventing the pin from falling out. The bearing reduces friction even further, but it
is not strictly necessary - the hole in the second link could simply be made smaller.
...