Versions Compared

Version Old Version 13 New Version 14
Changes made by

Mike Dow

Susanne Kraft

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

If the touch panel does not reset and connect, check the VLAN it is connected to is correct. Then check that the touch panel is set to the correct IP settings. Then make sure the IP table is setup correctly.

Press the buttons on the left-hand side of the Crestron room scheduler

in the order of top to bottom the first 4 buttons shown here.
Today = 1
Day < = 2
Day > = 3
Time = 4

Press them in sequence 1 – 4 (twice) in same order 1,2,3,4 (two) times

Press Save and Exit on the next menu that pops up.
The Crestron Touch Panel will reboot and should re-sync with the Outlook server and correct the scheduler to the current schedule

Image Removed


Image Added