Pro Tools - How to Record Sound or ADR "Automated" Dialog Replacement or Voice Over in CMB 1.106B

There are not any microphones in the room. We recommend the following mics:

Neumann TLM 103 or U87

Audio Technica 4050 or 4033

Here is a wiki on setting up and recording with these microphones.

Make sure that the thunderbolt to the AVID HD Native is plugged in should be two thunderbolt cables one going to the Blackmagic Intensity and one going to the AVID HD Native thunderbolt box

Make sure the XLR cable is plugged into channel 2 channel 1 has a slight noise problem but channel 2 is clean
Go to the >Apple>System Preferences
Go to the Blackmagic Design setting
Click on Blackmagic Design Intensity Extreme settings button
Set the following settings in this frame grab Output>Component Default Video standard as HD 720p 60
Open ProTools by clicking on the Applications folder and choosing Pro Tools
Create a blank session, name it and pick a place to save it Choose Type - Session (local) Choose a .wav file type Sample rate 48 Bit Depth 24 I/O last used Click on Location to navigate to where you want to save the project
Save to tempstorage or your storage drive Choose Open
Then choose Create
when protools is open Go to Setup>Playback Engine
Make sure it is set to HD Native Thunderbolt
If it is not then make sure that the thunderbolt to the AVID HD Native is plugged in. Try restarting computer too
Choose the menu labeled: Track>New... or press Command Shift N
Create: 1 new: Mono, Audio Track in: Samples
Click on the "Edit Window View Selector" dropdown in the Edit window. If you're in the mix window, press Command = to toggle to the Edit window.
Choose I/O
I/O will now have a check mark next to it.
You can now see the I/O column on your track in the Edit Window.
Click and hold the input drop down.
Choose Interface A2 from the input drop down.
Click and hold the output drop down.
Choose Stereo Monitor (Stereo) --> Stereo Monitor. This allows you to hear that track's output through this system's speakers. If you opened a previous session and need to hear other tracks playback through this system, then make sure their outputs are set like this as well.
Your I/O section should look like this.
Use these buttons to select a source to listen to: If you want to hear ProTools, then the button labeled ProTools needs to be pushed in and the red light illuminated. If you want to hear Avid, then the button labeled Avid needs to be pushed in and illuminated. You can leave them both pressed and illuminated.
Use this knob for Control Room Speaker Volume. Adjusting this knob will not affect the record level in Pro Tools. This knob only adjusts how loud the playback in the control room is.
Also make sure monitor A is selected on the MONITOR SELECT
Use the top knob (Phones 1) to control the sound booth headphones volume. Use the bottom jack and corresponding knob (Phones 2) for control room headphones…if you happen to bring some with you.
If the booth is not receiving audio then this button may be in the wrong position. Make sure it is in the "INPUT SOURCE(S)" position or UP.
Push this button to select either CR (Control Room) or push again to toggle to HP. Make sure CR is set to 00.
Next, Import the video into the project Choose Import Video Turn on the two Dell Monitors. 1 in sound booth and 1 in control room
Navigate to the video file that you want to view in the ProTools session
Choose to import at Session Start You do not have to choose "Import audio from file"