Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 19 Next »

To ease fabrication, given the materials and fabrication methods available, the initial CAD model was modified as shown in Fig. 1.






Fabrication of Links

The links, guide arm and carriage were additively manufactured (with Fused Deposition Modelling - FDM). This greatly simplified the task of fabricating the complex geometry of the guide arms in addition to reducing machining time required. PLA  was the fabrication material of choice as it is less susceptible to warping compared to other materials available for fabricating with FDM (e.g. ABS - see failed build with ABS in Fig. 2). Also, it provided enough strength and smoothness for the sliding of the rollers on the guide arms. To ensure holes were dimensionally accurate and properly-aligned, they were undersized in the CAD models and then drilled to the right sizes on a milling machine after printing.


Fig. 2: Failed build of guide arm (red) caused by excessive warping of ABS


Fabrication of Gears

The driver and driven gears transmitting motion from the motor were also fabricated with FDM. The gears were designed on geargenerator.com  and exported to STL format for printing. Dimensions were chosen to amplify the motor's torque output (MA=2.5). 


Baseplate and Stand

The baseplate was laser-cut out of a sheet of acrylic using a sketch of the baseplate surface from the CAD drawing.


Fig. 3: Baseplate


The stand was originally planned to be constructed from 8020 beams but due to unexpected shipping delays, an alternative had to be found. We choose to use wood legs as an alternative due to the wood shop having an extra supply of 2x4 available for use.

We cut two 3 ft pieces out of an 8ft 2x4 and subsequently cut those to pieces in half, giving us 4 legs. Using the jointer and planar machines in the wood we cleaned up the faces of each of the fours to achieve a smooth flat surface on each of the faces of the legs. After the facing was completed we cut the legs down to 2 ft while flattening the ends of each of the legs using the table saw.


Assembly

Mounting hubs, set screws, rolling bearings, and additively-manufactured retention rings were used to achieve tight-fits between the shafts and bearings.

The final assembly is shown below:


Fig



  • No labels