Note you will need 4 AA batteries 2 for each piece
Lavs come with two very similar looking pieces, a transmitter and a receiver. Transmitter is the end with the microphone connected to it
Receiver is the end that will plug into the Camera Plug the AF Out
Plug the other end to the Audio Input 2 of the camera
Here is the Receiver plugged into an audio mixer if you are using an audio mixer Plug the AF output into the Audio Receiver
Plug the mic into the transmitter Mic/Line input
The Transmitter is connected to the microphone. Attach the transmitter to the talent as shown here.
Start with the mic about 8 inches below your talent's chin and adjust it from there until it sounds natural in your headphones.
Make sure both units have 2 AA batteries each. Turn on each one by flipping down the case that holds the batteries and turn on the ON/OFF button till the ON light turns red for ON
ON light turns red for ON
Out of the box, the transmitter and receiver should have matching frequencies, meaning they can talk to each other wirelessly Make sure the frequency presets match Ex: B Ch. 6 2 shown here make sure they both match
To Change the frequency On the transmitter or receiver, press SET to activate the menu.
Press up/down buttons to select "Frequency Preset"
Use the Up and Down arrow buttons to change the frequency
To Set frequency hit SET Stored will show up when the frequency is saved.
then hit the on/off button to get out of the menus.

Browser not supported