Next we will setup how to send the signal to the Sony Production 3D monitors with SDI inputs (LMD4251TD)
On the back of the PMW – TD300 plug the L out and R out into the Sony LMD4251TD |
|
Plug in the SDI cables out of camera L to Option A1 on Sony TV |
|
Go to the "Format" settings – set to this screen grab. |
| ||||||
Go to the "Output" tab and set the Signal Format to these settings |
| ||||||
Now set up the Sony LMD4251TD |
| ||||||
Will turn green when on |
| ||||||
Use the Up, Down and Enter keys to navigate menus |
| ||||||
Go to
Signal Format (enter) change from side by side to Dual (enter) |
| ||||||
Then go to 3D signal Format and change to Dual |
| ||||||
Change to Dual |
| ||||||
A1 and A2 should be lit up RED to signify that there is an SDI signal coming in to both channels L and R |
| ||||||
Toggle F1 for Difference Mode |
| ||||||
If using Blackmagic 3D hardware put the Sony LMD425 into side by side mode |
| ||||||
Go to User Config Menu (enter) then go to 3D setting (enter) |
| ||||||
Then go to 3D signal Format and change to Dual |
| ||||||
If using Blackmagic 3D hardware put the Sony LMD425 into side by side mode |
|
