ON CAMPUS - The following instructions are for on campus use. This uses the utexas-iot wifi.

BEFORE YOUR SHOOT CHARGE THE BATTERIES PLUG IN THE CAMERA WITH THE BATTERIES IN THE Camera and let it charge till all the batteries are charged The orange light will be blinking on the camera while the batteries are charging. 4 blinks = less than 25% charged 3 blinks = less than 50% charged 2 blinks =less than 75% charged 1 blink = less than 100% charged	Image Modified
Setup the remote camera like you normally would. Probably with a tripod.	Image Modified
Plug your lav or handheld into Input 1. If you do not, the control room will not have audio from you.	Image Modified
Make sure your input settings are correct. Channel 1 should be set to Input 1.	Image Modified
Power On the camcorder by pushing in the blue release button and sliding the switch to the ON position	Image Modified
This symbol will flash and then turn solid yellow. It will turn from solid yellow to solid white. When it looks like this it is ready to stream to the control room.	Image Modified
Press the OIS/2 button. This will start streaming video back to the control room.	Image Modified
You should see a little red "LIVE" icon in the top of the camera view finder screen	Image Modified
Not working? Try loading the On Campus configuration by: 1. pressing the menu button 2. Choose System... 3. Choose Network Settings... 4. Choose Connection Setup... 5. Choose Load 6. Choose CAM1 ONCAMPS 7. Set 8. Load	Image Modified

OFF CAMPUS - The following instructions are for off campus use. This uses the student's cell phone data via their hot spot.

...

Press and hold the REMOTE IFB button on the panel above the mixing console to speak to the remote remote camera in the field.
Press and hold the REMOTE IFB button on the panel in the producer area to speak to the remote remote camera in the field.
On the audio board the audio from the remote camera will come up on REM
on the Program bus choose REMOTE / CAM
Not working? Try loading the On Campus configuration by: 1. pressing the menu button 2. Choose System... 3. Choose Network Settings... 4. Choose Connection Setup... 5. Choose Load 6. Choose CAM2 OFFCAMPS 7. Set 8. Load

...