...
You will need: -Soundcraft Performer SI3 mixer -iPad -ViSiRemote App for iOS (only works on iPad) -ViSiListen App for iOS (works on iPhone and iPad) -Wireless Router | |
| Plug the router into the back of the Mixer. In HiQnet port. The plug on the router should not be WAN (Internet), it should be LAN. |
 |
| Press System |
|
Make sure the board has an IP address. You can set it to static if you know what you're doing, but here we have set it to DHCP because it makes things easier. If your mixer board does not have an IP address restart the mixer by holding the power button for 3 seconds and then pressing the button again, to power off. Then press the button once to turn on. Do this while the wireless router is on. |
|
| Choose HIQnet from the main menu of the mixer board. |
|
Enable HIQnet. You'll have to reboot to apply. Enable Access Control. Tell Device 1 to have "All" Then you will need to find the HIQnet number in the next step |
|
| On the iPad under settings scroll all the way down to "ViSiRemote" |
|
| This is the HIQnet of your IOS device...take note of this, you will need it in the Mixer board. |
|
| Under HIQnet in the mixer board settings, choose "Address Assign" while Device 1 is highlighted |
|
| Punch in the number of your iOS device |
|
| You might have to hit apply |
|
| The screen should look like this |
|
| You also may have to power cycle the board. |
|
| Make sure you're on the wireless network that the board is on. For us it is TP-LINK_1096 |
|
| Launch VisiRemote on the iPad |
|
After a few seconds, your board should show up on the left hand side of the App The number in front of the "Si Performer 3" is the HIQnet address of that particular board. |
|
| Then you should have control. |
Things to know:
HIQnet addresses cannot be the same...Ex: the board's HIQnet and the iOS HIQnet should be different.
ViSiRemote is for main mix and more of a total control
...