Use Camera 01 |
| ||||||
Use the remote camera controls to setup the camera brightness and levels |
| ||||||
Use Salvo 4E |
| ||||||
Lighting use the News and BG preset |
| ||||||
Wheatstone Audio Board press the studio select button for 5 sec and then press Studio 4E |
| ||||||
Lav Mics are in the drawer in the control room take out two and replace the AA battery |
| ||||||
XLR Cables hang here for mics extension to plug into the XLR inputs under the desk |
| ||||||
Plug in the two mics under the desk |
| ||||||
Turn on Channel 01 and 02 |
| ||||||
Pan the 01 track to the left and the 02 track to the right |
| ||||||
|
| ||||||
Pick the Channel you would like to change the input and hold down the A/B button or "OverPress" it till it lights up RED |
| ||||||
The Input channel of the slider will appear in the Wheatstone Interface software as the selected tab. In our example Input 12. |
| ||||||
Press the Input Source Knob that is on the audio board in the upper right quadrant. Turn the knob and while turning look at the LED on the slider channel and will see the sources changing. |
| ||||||
Look at the LED name of the channel you would like to change and you will see the input change as you twist the knob |
 | ||||||
When you get to the source you would like to select press the top of theInput Source Knob again to assign the input |
| ||||||
Now if you look at the input you will see the new source |
| ||||||
Make sure you toggle OFF and ON the Channel for the change to take effect. |
|
Page Comparison
Manage space
Manage content
Integrations