Initial Design
Figure 2 depicts the kinematic diagram of our initial idea. The mechanism consists of two robotic arms grounded to a board. The three bar mechanism has an end effector (shown in orange) that will grip the avocado. The end effector will rotate the avocado about the x-axis and the upper link (link 1) of the arm will rotate about the y-axis. While holding a knife at the end effector, the 5 bar mechanism will be able to perform three motions. Links 6 and 7 will be able to rotate about the z-axis with angles θ6 and θ7, respectively. Link 4 will be able to rotate about the x-axis. This link will be fixed to link 5, allowing the entire arm to move along the z-axis.
Figure 2: Initial design sketches
Second Design & Prototype
We quickly changed the design in order to be appropriate for the class. The desire for the class was a closed chain kinematic system while our initial design was two open chain robotic arms.
Figure 3: CAD of second design
Figure 4: Prototype of second design
As seen in Figure 4, the torque output of the servo was not high enough for the knife to go through the pit. We realized that a high torque servo was required for the final prototype. Additionally, there are motions in two planes required. Typically when one removes a pit from an avocado they cut down into the pit, twist the knife to loosen the pit from the avocado flesh, and then lift the knife and pit out of the avocado. This twisting motion was implemented in our final design.