1.

Turn on both switches on wall

2.

Route studio 4E using the video router

Press Back

Press Salvo

Choose Studio 4E

3.

Route the 4E audio

Push and hold shift for 5 seconds 

While holding SHIFT choose Studio 4E

4.

Set up audio board

Turn on the button and bring slider up that corresponds

with the mic input you are using.

Turn on MASTER fader and slide up

(if you are using more than 1 microphone)

Pan Mics Left and Right

On one of the Mic sliders hold the A/B button at the very

top of the slider.

Use the pan knob to pan to the LEFT

Repeat this for the other microphone but pan to the RIGHT

5.

Roll CAM 1 into position & position partitions

Turn on camera (if off)

6.

Plug in XLR wired mics

Mics are in the cabinet in the control room

Insert AA battery in mic

Use the XLR cables located in the studio

Plug the mics into 3 and 4 underneath the news desk

7.

Set up studio for white balancing the camera

Turn on lighting preset - BG

Turn off HOUSE lights

Place the white foam board (from the easel) in position

Zoom camera all the way to the white board

Go to Manual Mode

Press ABB to black balance the camera

Adjust IRIS of camera - Turn IRIS knob on bottom left

Turn the knob until the Waveform Monitor video signal

touches the 80 IRE mark (indicated with a --------- line.)

Now that the video levels are set - Press AWB

Before White Balance

After White Balance

8.

  Set up Ki Pro recorder

Insert Compact Flash card

Format Compact Flash card

Press MEDIA button

Press SELECT up/down arrows,

navigate to Format Media.

Use the ADJUST UP button to select FORMAT.

Press and hold the ADJUST UP arrow 

button for 2 seconds

If you are using two compact flash cards

Press the SLOT button to switch to the 2nd card and

repeat the last steps