The Linux computer is under the desk. Plug in your Source HD (Mac Formatted)
Also Plug in the USB or Secondary HD that will be formatted to EXT2 or EXT3 |  |
Press the source button to get to the VGA input.
DVI = Mac Computer VGA = Linux Computer |  |
 | Log in with the password rtfdcppkg
This computer is not on the internet so you will have to connect your hard drive with the DCP on it to the computer directly via USB. |
Go to Applications You will have to re enter the password |
|
Go to the upper left and choose the correct drive to format |
|
Selected drive has to be unmounted |
|
Next right click and choose >Format to>ext2,ext3 or ext4 |
|
Next click the "green checkmark" to apply all operations
|  |
| The formatting takes a while. A 30 gig USB will take about 10 to 15 minutes. |  |
|
|
Right click the drive in the side bar to get the properties |
|
Open terminal and type in
sudo chmod 777 and type in the following:
sudo chmod 777 /media/cmb4112/ (followed by the name of your drive)
Use the name of the drive shown in the properties of the above example.
Here is an example:
sudo chmod 777 /media/cmb4112/6ebcdf21-f950-432d-b05c-32361936626d (or the name of your particular drive don't use this example)
Finally copy the DCP files from your Macintosh HD to the EXT3 formatted hard drive.
When files finish copying over you can remove your Hard Drive from the computer.
Right click the drive in the sidebar and choose > Safely remove |  |
|---|