This will guide you through setting up the studio to shoot one camera interviews.
The steps include:
- Turn on studio wall switches
- Route the 4E Studio in the video router
- Route the 4E audio in the Wheatstone controller
- Set up audio board (Turn mics on and pan left/right)
- Set up Studio - position camera and partitions
- Plug in wired lavalieres under the news desk
- White balance camera
- Set up KiPro compact flash recorder
(hyperlinks above link to more detailed instructions for each step)
1.Turn on both switches on wall |  | ||
2.Route studio 4E using the video router
| Press Back
| Press Salvo
| Choose Studio 4E
|
3.Route the 4E audio
| Push and hold shift for 5 seconds
| While holding SHIFT choose Studio 4E
| |
4.Set up audio board
| Turn on Mic 3 and Mic 4 and bring slider up
| Turn on MASTER fader and slide up
| |
Pan Mics Left and Right
| On Mic 3 press & hold the A/B button at the top
| Use the pan knob to pan to the LEFT
| Repeat this for Mic 4 but pan to the RIGHT
|
5.Set up studio  | Roll CAM 1 into position & position partitions  
| Turn on camera (if off)
| |
6.Plug in XLR wired mics | Mics on in the cabinet in the control room
Insert AA battery in mic
| Use the XLR cables located in the studio
| Plug the mics into 3 and 4 underneath the news desk
|
7.Set up studio for white balancing the camera | Turn on lighting preset - BG
| Turn off HOUSE lights
| Place the white foam board (from the easel) in position
|
| White balance camera in the control room | Press the LAB E CAM 1 button | Go to Manual Mode
Press ABB to black balance the camera
| Adjust IRIS of camera - Turn IRIS knob on bottom left
Turn the knob until the Waveform Monitor video signal touches the 80 IRE mark (indicated with a --------- line.)
|
Now that the video levels are set - Press AWB
| Before White Balance
| After White Balance
| |
8.Set up Ki Pro recorder | Insert Compact Flash card
| Format Compact Flash card Press MEDIA button
Press SELECT up/down arrows, navigate to Format Media.
Use the ADJUST UP button to select FORMAT.  Press and hold the ADJUST UP arrow button for 2 seconds
| Press the SLOT button to switch to the 2nd card and repeat the last steps
|
