Controls Connectors & Wire Harnessing
- 1 General
- 2 Lighting Board (Minion) + Display Harness
- 2.1 Connectors
- 2.2 Harness
- 3 CarCAN Harness
- 3.1 Connectors
- 3.2 Harness (x2)
- 4 Array Contactor Harness
- 4.1 Connectors
- 4.2 Harness
- 5 Motor Contactor Harness
- 5.1 Connectors
- 5.2 Harness
- 6 MotorCAN Harness
- 6.1 Connectors
- 6.2 Harness
- 7 Pedal Test Harness (Simboard)
- 7.1 Connectors
- 7.2 Harness (x2)
- 8 Ignition Switch Test Harness (Simboard)
- 8.1 Connectors
- 8.2 Harness
- 9 Test Power Harness
- 9.1 Connectors
- 9.2 Harness (x2)
- 10 Dashboard Controls (Production)
- 10.1 Ignition Switch
- 10.2 Connectors
- 10.3 Harness
- 10.4 Buttons (x3)
- 10.5 Gears and Blinkers (3-Position Switch)
- 10.6 Connectors
- 10.7 Harness (x2)
- 10.8 Hazard Lights (2-Position Switch)
- 10.9 Internal Turn Indicator Light (x2)
- 11 Lights (Production)
- 12 Brake Pedal Harness (Production)
- 12.1 Connectors
- 12.2 Harness
- 13 Accel Pedal Harness (Production)
- 13.1 Connectors
- 13.2 Harness
General
This page is meant to detail all of the connectors needed for the controls system to run, both on our test bench or in the car (production). Noted below for each harness are the relevant connectors as well as the pin-to-pin connections.
LV Harnessing TODO:
3 button harnesses
2 three-position switch harnesses
1 two-position switch harness
1 six-position switch harness
Accelerator pedal harness
Brake pedal button harness
Lights:
2 daytime running light harnesses
Front turn indicators
Side marker turn indicators
Rear turn indicators
Rear brake lights
High mounted center brake light
HV Harnessing TODO:
O-ring to O-ring connector from Motor Precharge Bypass Contactor → Motor Controller
Lighting Board (Minion) + Display Harness
Connectors
Connector Name | Part Link | Image |
|---|---|---|
Controls_Leaderboard_J5 - Controls Lighting/Display Connector (AKA Minion Connector) |  | |
Controls_Display_UART - UART Interface Connector for Nextion Display (nx4827t043) | Top to bottom 1 - GND 2 - RX 3 - TX 4 - 5V | |
Controls_Leaderboard_J24 - Controls Extra GPIO Connector | 2x4 Pin Headers (not molex) | |
Controls_Lighting_J1 - Controls Lighting Main Connector | |
Harness
From Connector | Pin Number | To Connector | Pin Number |
|---|---|---|---|
Controls_Leaderboard_J5 | 1 (5V) | Controls_Display_UART Controls_Lighting_J1 | Display: 4 (5V) Lighting: 8 (5V) |
2 (GND) | Controls_Display_UART Controls_Lighting_J1 | Display: 1 (GND) Lighting: 9 (GND) | |
3 (MOSI) | Controls_Lighting_J1 | 6 (CEN) | |
4 (MISO) | Controls_Lighting_J1 | 5 (REV) | |
5 (BPS_PWR) |
| ||
6 (UART3_Tx) | Controls_Display | 2 (RX) | |
7 (UART3_Rx) | Controls_Display | 3 (TX) | |
8 (CLK) | Controls_Lighting_J1 | 4 (FOR) | |
9 (CS) | Controls_Lighting_J1 | 3 (REG) | |
10 |
|