/
V. Electronics and Software - GRA

V. Electronics and Software - GRA

May 13, 2022

Electronics:

MG995 Servo was used for the Gripper Mechanism.

 

HS-755HB Servo was used for the Arm Mechanism.

 

Arduino Uno was used as a microcontroller for the system.

 

6V AA Battery Pack was used as an external battery to power the two servos.

 

Wiring:

  • The servos were wired up through a breadboard. (Shown Below)

  • They both had common ground with the Arduino Uno but were fed power through an external power source. (Shown Below)

  • The servos were controlled by PWM cables on the servos that were connected to the PWM digital pins on the Arduino Uno. (Shown Below)

  • Joy Sticks were connected using analog signals to the Arduino Uno. (Shown Below)

 

Code:

The code is set up in a way so that the servos are fed position values depending on the position of the joystick, which is essentially a potentiometer.

The joystick outputs values in a range from 0 to 1023 and they are mapped to the desired range of servo positions.

For the gripper, it had 85 degrees of motion, while the arm had 75 degrees of motion.