Lighting Enclosures
Project Overview
This project entails the creation of Front, Side, Canopy, and Rear lighting enclosures for the lighting boards. The base enclosure will be uniform and there will be a distinct mount for every location, matching the curved profile of the aeroshell. The mounts for the front and sides will be epoxied to the bottom shell while the canopy and rear enclosures will be mounted to the top shell bulkheads.
Project Owners: Riley Nguyen
Resources:
000
Electrical Counterpart
VCAT → Controls Subsystem
Lighting Board Project
Electrical POCs:
@Frank Li - Electrical Lead
@Eliana Tejeda - Lighting Board Project Owner
@Akshay Gaitonde - VCAT Lead
@Mikail Sadic - Controls Sublead
Project Requirements
4130 Tab Mounting
Gasket Seal
Board Accessibility
Subtasks
Design
Enclosure
Mounting
Test Prints
Manufacture and Integration
Documentation
Used Telemetry enclosure for basic design
Heat set inserts holes are 4.5mm wide and 5.5mm deep, 3.2mm thru holes
2x8 pin MX150 Key A right angle through side wall of enclosure
0.25mm tolerance for lid guides
70mm x 80mm x 36mm
Lid seat offset 2mm from body wall
PCB dimensions 35.5x50mm